with LeeVaiiey.
Because it was simple and easy to use, one unit was decided to be made referring to this for
the open class.
@
@
It is the iron plate of 400~ 600mm, 4mm thickness.
Then, the hole of 80~ 80mm is made in the center.
It thinks that it was probably 2`3000 yen though a price was forgotten because they are very former times.
There must be some bolt holes in the base plate of the router in any manufacturer.
And, a hole is made together in the iron plate, and the plate screw of 6mm is fixed.
Because a screw couldn't fix it, adhesive was used with the screw cutting together, and three bolts were fixed.
The fixation of the router is probably sufficient with the butterfly nut.It is usually unnecessary though
a hole for the reverse was made to have the direction of Router changed this time.
@
@
It is only put on the frame of the body.
A body fixes plywood of 20mm with the screw and the adhesive.
The front of the top is raised, and the exchange of the bit and the adjustment of the
height are done.
@
@
@
@It thinks that it will be purchased by the addition someday.
But,it doesn't need to buy a tall fence forcefully.
The way of tightening a clamp lightly and attacking it with the hammer and
adjusting it is simple, and you will be able to adjust it precisely.
It is the same as the edge of the plane.
@
@@
@to the photograph and the figure.
A left figure can expand by clicking.
To fix a fence in which direction as well with the
clamp.
It lets an iron plate go to circumference from the
body 40mm.
Bottom : Because it can't be done for on if grip
isn't seized, my router winds grip by the rubber tape,
and fixes a switch.
Therefore, the switch of the power supply is necessary
for the outside of the body.
This is power-switch of the site MLCS where it is satis
-factory about the router.
When the bit of the router was bought, this and Foot
-Switch were bought, too.
Such a thing is not easily in Japan, either.
It was made of the veneer because it was not here though
the acrylic board of the insertion plate of the top was good.
@
@
In this open class, there is a process to create tenon in the leg part.
It thought that this was intended to be processed easily.
@
@@
@Once this is used, the bit of the strike rate can't be used.
Though it is very expensive, but cutting resistance isn't small, and it is accurate and safer
than what.
This is purchased with MLCS, too, and three sets are $49.95s! But, it is inch diameter. Then,
of course postage is added.
If it does its best and it can negotiate to send it by aviation air-mail, about 8$.
When it is in such cases as UPS, 25-30$ is necessary.
But, when it is made in Japan, 1 will do about 20000 yen with 12MM.
@
@@
©The subject of the open class.
